XCAP Control Panel for the IDT M-5 Mono with the PIXCI® EL1(Rev7+)

XCAP software software provides easy to use controls for the IDT M-5 Mono camera as supported by the PIXCI® EL1(Rev7+) frame grabber using the PCI Express x1 Gen 2 bus/interface. After following the camera manufacturer's directions to configure the camera, these controls allow easy configuration of the frame grabber to match!

(XCAP Control Panel for the IDT M-5 Mono)

Try these controls: Download, install, and run XCAP. Click PIXCI®, PIXCI® Camera Info. Click under 'Adjust Dialog' to launch interactive controls for this or any other supported camera.

Back to the PIXCI Selection Guide