XCAP Control Panel for the PhotonFocus MV-D1024E with the PIXCI® e104x4-2f

XCAP software software provides easy to use controls for the PhotonFocus MV-D1024E camera as supported by the PIXCI® e104x4-2f frame grabber using the PCIe/104 x4 Gen 2 bus/interface. After following the camera manufacturer's directions to configure the camera, these controls allow easy configuration of the frame grabber to match!

(XCAP Control Panel for the PhotonFocus MV-D1024E)

Try these controls: Download, install, and run XCAP. Click PIXCI®, PIXCI® Camera Info. Click under 'Adjust Dialog' to launch interactive controls for this or any other supported camera.

Back to the PIXCI Selection Guide